Home
Trending
Arduino UNO R3 DIP 328P-PU + USB Cable
3.840 KWD
HC-SR04 Ultrasonic Wave Distance Sensor
0.800 KWD
1.440 KWD
Featured Products
Tecsa Widescreen HD Webcam TC200
3.600 KWD
Arduino UNO R3 DIP 328P-PU + USB Cable
3.840 KWD
1.440 KWD
Communication Units
There are 17 products.
1.600 KWD
ESP8266EX ESP-01 Wireless WiFi Transceiver Receiver 1MB DC3.0-3.6V Internet of Things
Out-of-Stock
ESP8266EX ESP-01 Serial Wireless WiFi Transceiver Receiver Module 1MB SPI Flash DC3.0-3.6V Internet of Things WiFi Module Board Compatible with Arduino
Model: Esp-01.Compatible with Arduino. Support 3 modes: AP, STA, AP + STA
2.12.0.0
Model: Esp-01.Compatible with Arduino. Support 3 modes: AP, STA, AP + STA
2.12.0.0
1.440 KWD
GPS GT-U7 NEO-6M 51 Single Chip Navigation Satellite Positioning Module
Out-of-Stock
GPS GT-U7 NEO-6M 51 Single Chip Navigation Satellite Positioning Compatible Module
4.400 KWD
GPS Module GY-NEO6M PPS With Flight Control EEPROM Controller MWC APM2.5 + Antenna
Out-of-Stock
NEO-6M GPS Module with Flight Control EEPROM MWC APM2.5
2.800 KWD
GPS NEO-8M Satellite Positioning Module Arduino STM32 C51 51 MCU Microcontroller
Last items in stock
GPS NEO-8M Satellite Positioning Module Arduino STM32 C51 51 MCU Microcontroller
3.360 KWD
GY-NEO6MV2 NEO-6M GPS Module 3-5V + Super Strong Ceramic Antenna
Out-of-Stock
GY-NEO6MV2 NEO-6M GPS Flight Controller Module 3V-5V with Super Strong Ceramic Antenna for Arduino EEPROM APM 2.5- Module with a ceramic antenna, superior signal- Save the configuration parameter data EEPROM Down- With data backup battery;With LED signal indicator- Default baud rate: 9600, Interface: RS232 TTL- Compatible with a variety of flight control module
2.800 KWD
1.600 KWD
HC-06 Slave Bluetooth 2.0 Module
Last items in stock
HC-06 Bluetooth Serial Pass-Through Module
Works with any USB Bluetooth adapters.
Default Baud Rate: 9600,8,1,n.
Built in antenna.
Coverage up to 30ft.
Works with any USB Bluetooth adapters.
Default Baud Rate: 9600,8,1,n.
Built in antenna.
Coverage up to 30ft.
1.600 KWD
HM-10 Master & Slave Bluetooth 4.0 Module
Last items in stock
Bluetooth master and slave moduleThrough the AT command, you can set this bluetooth module to the master mode can also be set to slave mode, even in iBeacon way work .it also Supports Apple Notification Center Service (ANCS)
base Board 4 PIN, leads to VCC, GND, TX, RX. You can be very convenient to connect to your arduino project or other DIY project
Working voltage 3.6 V to 6V,Default rate of 9600.There are 4PIN dupont cable in the package
base Board 4 PIN, leads to VCC, GND, TX, RX. You can be very convenient to connect to your arduino project or other DIY project
Working voltage 3.6 V to 6V,Default rate of 9600.There are 4PIN dupont cable in the package
1.600 KWD
LoRa 433MHz SX1278 long range RF wireless module DRF1278F
In-Stock
LoRa 433MHz SX1278 long range RF wireless module DRF1278F
2.400 KWD
2.240 KWD
NRF24L01 2.4GHz Wireless RF Transceiver Module + Adapter 8 Pin 3.3V Regulator
Last items in stock
NRF24L01 2.4GHz Wireless RF Transceiver Module with NRF24L01 Socket Breakout Adapter 8 Pin Plate Board Breakout Adapter with on-Board 3.3V Regulator
NRF24L01 Wireless Transceiver Module: Built-in 2.4Ghz antenna: available software to set the address, only received local address when output data(Provide interrupt instruction), can be directly connected to a variety of microcontrollers. Compatible with Arduino and Raspberry Pi.
NRF24L01 Wireless Transceiver Module: Built-in 2.4Ghz antenna: available software to set the address, only received local address when output data(Provide interrupt instruction), can be directly connected to a variety of microcontrollers. Compatible with Arduino and Raspberry Pi.
0.960 KWD