وحدات الاتصال

NRF24L01 Wireless Module Transceiver 2.4 GHz + SMA Antenna +  Breakout Adapter On-Board 3.3V Regulator - Arduino
【NRF24L01】is 2.4GHz ISM band transceiver for arduino, which has the abilities of auto-acknowledge and auto-retransmit and support up to six channels of data reception.
【NRF24L01】Includes on board support components and the RFX2401C which is the PA (Power Amplifier) and LNA (Low-Noise Amplifier)
【NRF24L01】The module has 5V tolerant inputs which allows for direct connection of SPI pins to the Arduino.
【Wireless Module】Small power on SMD LED indicator; On-board 3.3V voltage regulator accepts your Arduino +5V supply and provides 3.3V for the attached "NRF24L01+" module.

GY-NEO6MV2 NEO-6M GPS Flight Controller Module 3V-5V with Super Strong Ceramic Antenna for Arduino EEPROM APM 2.5- Module with a ceramic antenna, superior signal- Save the configuration parameter data EEPROM Down- With data backup battery;With LED signal indicator- Default baud rate: 9600, Interface: RS232 TTL- Compatible with a variety of flight control module

SIM800L V2.0 5V Wireless GSM GPRS Module Quad-Band W/Antenna Cable Cap M105

HC-06 Bluetooth Serial Pass-Through Module
Works with any USB Bluetooth adapters.
Default Baud Rate: 9600,8,1,n.
Built in antenna.
Coverage up to 30ft.

Bluetooth master and slave moduleThrough the AT command, you can set this bluetooth module to the master mode can also be set to slave mode, even in iBeacon way work .it also Supports Apple Notification Center Service (ANCS)
base Board 4 PIN, leads to VCC, GND, TX, RX. You can be very convenient to connect to your arduino project or other DIY project
Working voltage 3.6 V to 6V,Default rate of 9600.There are 4PIN dupont cable in the package