الصفحة الرئيسية

NRF24L01 Wireless Module Transceiver 2.4 GHz + SMA Antenna +  Breakout Adapter On-Board 3.3V Regulator - Arduino
【NRF24L01】is 2.4GHz ISM band transceiver for arduino, which has the abilities of auto-acknowledge and auto-retransmit and support up to six channels of data reception.
【NRF24L01】Includes on board support components and the RFX2401C which is the PA (Power Amplifier) and LNA (Low-Noise Amplifier)
【NRF24L01】The module has 5V tolerant inputs which allows for direct connection of SPI pins to the Arduino.
【Wireless Module】Small power on SMD LED indicator; On-board 3.3V voltage regulator accepts your Arduino +5V supply and provides 3.3V for the attached "NRF24L01+" module.

51 MCU development board STC89C52 learning board AVR minimum system AT89S51
1. Product Name: nh5100 development board
2. Main control chip: STC89C52
3. Crystal frequency: 11.0592m/12m

Smart Car Robot Tire Wheel with DC 3-6v Gear Motor
Parameter Operating voltage: 3V ~ 6V DC
Reduction ratio: 1:48
Maximum torque: 800k.cm
Tire diameter: 65mm,Tire thickness: 28mm

GY-NEO6MV2 NEO-6M GPS Flight Controller Module 3V-5V with Super Strong Ceramic Antenna for Arduino EEPROM APM 2.5

Mini MP3 Player Audio Voice Module TF Card U Disk Board for DFPlayer Audio Voice Music Module
Supports sampling rates (KHz): 8/11.025/12/16/22.05/24/32/44.1/48
MP3 Player Audio Voice Module

SIM800L V2.0 5V Wireless GSM GPRS Module Quad-Band W/Antenna Cable Cap M105

HC-06 Bluetooth Serial Pass-Through Module
Works with any USB Bluetooth adapters.
Default Baud Rate: 9600,8,1,n.
Built in antenna.
Coverage up to 30ft.

Speaker small magnetic speaker 3W 4R 3 W 4 ohm diameter 36MM thick 20MM cone magnetic

Speaker small magnetic speaker 1W 8R 1 W 8 ohm diameter 66MM thick 12.7MM cone magnetic

SG90 9G Micro Servo Motor Kit for RC Robot Arm Helicopter Airplane Remote Control

Bluetooth master and slave moduleThrough the AT command, you can set this bluetooth module to the master mode can also be set to slave mode, even in iBeacon way work .it also Supports Apple Notification Center Service (ANCS)
base Board 4 PIN, leads to VCC, GND, TX, RX. You can be very convenient to connect to your arduino project or other DIY project
Working voltage 3.6 V to 6V,Default rate of 9600.There are 4PIN dupont cable in the package

Micro SD TF card reader module SPI interface with chip level conversion
Support Micro SD card, Micro SDHC card (high speed card)
board level conversion circuit, namely the interface level for 5V or 3.3V
power supply is 4.5V ~ 5.5V, 3.3V voltage regulator circuit board
The communication interface is a standard SPI interface
M2 screw positioning holes for easy installation